Question How do I remove the big metal shroud on my NZXT B550?

[Sneed96]

I dropped an m.2 screw and it rolled under the large metal cover. On the NZXT website it says you can remove it to access to CMOS battery but I can’t figure out how.

 

[rgd1101]

look like there are screws. see if the manual help

 

[Sneed96]

look like there are screws. see if the manual help

Manual doesn’t say much at all about how to do it.

 

[scout_03]

board nanual page 13-14 they use clip .

 

[Sneed96]

board nanual page 13-14 they use clip .

I don’t understand what do you mean. What clip? What and how do I do it?

 

[scout_03]

from manual there are no screw holding them the should be little tab that hold them on they call it clip check on the board this show you how https://www.kitguru.net/components/motherboard/luke-hill/nzxt-n7-b550-motherboard-review/all/1/

 

[Sneed96]

Nvm I managed it. On the underside of the board you need to unscrew all the screws that bulge out (not the flatter ones). I meant the main metal cover not the one over the m.2 slots btw.