How to set internal wires in gigabyte h110 m s2

[RaoSid94]

I want to connect power wires,red Orange ,green and blue .
First it is written +P Led-,down to it is written+HD-,next line +PW-,below that is -RES+.Waiting for your reply....

 

[USAFRet]

I want to connect power wires,red Orange ,green and blue .
First it is written +P Led-,down to it is written+HD-,next line +PW-,below that is -RES+.Waiting for your reply....

The motherboard and case user manuals will show you where everything goes.

 

[nukemaster]

It is in the manual

P led is the power led. It is polarity sensitive so match + and -
HD is the drive led. It is polarity sensitive so match + and -
PW is a switch to turn the system on and off. It should not be polarity sensitive
RES is the reset switch. again not polarity sensitive.

 

[RaoSid94]

It is in the manual

P led is the power led. It is polarity sensitive so match + and -
HD is the drive led. It is polarity sensitive so match + and -
PW is a switch to turn the system on and off. It should not be polarity sensitive
RED is the reset switch. again not polarity sensitive.

RED or RES ?

 

[nukemaster]

I mean res 😛

my bad.

What case are you using? take a picture of your headers. They should all have writing on one side showing what they are. Older cases did not and you had to follow the wires back to the leds and switches

Not all cases even use all of these. I have a case with just one led(power) and one power switch. It has no reset or HDD led. I connected the power led to the HDD header on the board because I would rather see hard drive activity.