Currently, the plan is to use 3x 5700xts for 100$ each, a generally reputable mobo with a custom printed frame, and purchase three risers for the mobo that will feed inside of a glass tank. Inside this tank would be mineral oil. I have little experience with miners or how to run them properly much less how to run a tank but if I had to guess the proper prep would be to deep clean the 57xt's and then proceed to run them in the cleaned tank. Keep the tank air-tight and swap out the oil after a while to remove as many impurities as possible. continuing from there it may be a good idea to purchase a motor that can move the oil around to replenish the contacting oil on the chip. I was considering 98% isopropyl with an air-tight seal and a powerful motor to create a very fast-flowing current but after doing some reading it may not be as effective or reasonable as I hoped.