Question "Is a Slightly Tilted Power Switch on My PSU Insignificant?"

[Lirou]

https://imgur.com/a/xMhXXXV

View: https://imgur.com/a/xMhXXXV

 

[Colif]

Image posting via Imgur

go here - https://imgur.com/ you might need to set up a user. click on New Post which will display next screen where you can select image(s) - hold Ctrl while selecting images in explorer to get multiple Once uploaded, images will show on the next page right clicking an image (once its shown...

forums.tomshardware.com

Minha PSU chegou com o interruptor de energia ligeiramente inclinado. Isso pode afetar a PSU ou seria considerado insignificante?"

Translation:
My PSU arrived with the power switch slightly tilted. Could this affect the PSU or would it be considered insignificant?

 

[Lirou]

Image posting via Imgur

go here - https://imgur.com/ you might need to set up a user. click on New Post which will display next screen where you can select image(s) - hold Ctrl while selecting images in explorer to get multiple Once uploaded, images will show on the next page right clicking an image (once its shown...

forums.tomshardware.com

Tradução:
Minha PSU chegou com o interruptor de energia ligeiramente inclinado. Isso pode afetar a PSU ou seria considerado insignificante

Sorry, I'm still learning to use this site, and my phone automatically translated the message I sent in English to Portuguese. I truly apologize, I will send the correct Imgur link now."

https://imgur.com/a/eyhChuJ

View: https://imgur.com/a/eyhChuJ

 

[BFG-9000]

It's a snap-in switch. You can try completing the assembly process by forcibly pressing the surround of the switch inward. If that doesn't help, either the plastic molding of the switch tabs was manufactured incorrectly or some wires are attached without enough slack to allow it to seat completely. In any case this shouldn't affect operation, it's only unsightly.

 

[Misgar]

If the hole in the PSU metalwork is slightly too small, or the paint is too thick, or the plastic moulding on the switch is slightly too big, the switch might not fit properly. Poor Quality Control missed this assembly error during inspection (if they even checked).

If you do attempt to "force" the switch all the way down, do not press down really hard on the rocker itself, just the around the edge. You might damage the switch. Personally, I'd leave well alone.