Is Corsair 3200Mhz compatible with Gigabyte GA-AB350M-Gaming 3? (Ryzen)

[lafiexs9]

Hello guys, im gonna upgrade my pc to Ryzen 5 1600 with Gigabyte GA-AB350M-Gaming 3. I made some research about rams and i saw that with 3200mhz i would have better perfomance, but there's a lot problems of compatibility, is Corsair Vengeance Lpx 16gb (2x8gb) 3200mhz compatible? i can run them at 3200mhz without any problems?

This will be the setup:

CPU: Ryzen 5 1600
Mobo: Gigabyte GA-AB350M-Gaming 3
RAM: Corsair Vengeance LPX 16GB (2 x 8GB) DDR4-3200
GPU: GTX MSI 1060 6GB Gaming X

Thanks

 

[vapour]

It is compatible, but running 3200 is a different story. Can you find G.Skill ones? They usually perform better and are more likely to run 3200.

 

[JalYt_Justin]

It is compatible but there is no guarantee that it hits 3200MHz. My G.Skill TridentZ RGB couldn't even hit 3200MHz on my board, and generally G.Skill makes better RAM of the two.

There's a good chance you hit 2933, but after that it's basically a dice roll. As always, it's best to get RAM from your motherboard's QVL and buy those specific kits. Otherwise you're playing a gambling game.

 

[lafiexs9]

It is compatible, but running 3200 is a different story. Can you find G.Skill ones? They usually perform better and are more likely to run 3200.

Yes i can, but only the TridentZ and Ripjaws V, there's no stock for Flare X ones, should i go for any of these instead of corsair?

 

[lafiexs9]

It is compatible but there is no guarantee that it hits 3200MHz. My G.Skill TridentZ RGB couldn't even hit 3200MHz on my board, and generally G.Skill makes better RAM of the two.

There's a good chance you hit 2933, but after that it's basically a dice roll. As always, it's best to get RAM from your motherboard's QVL and buy those specific kits. Otherwise you're playing a gambling game.

Thanks, on my mother's qvl list the only that is supported and i can buy on my country is Gskill RipjawsV, corsair ones are not supported on 3200mhz, so i think i will go for the gskills one, thanks again!

 

[vapour]

either works, my ripsaw is running 3200 for my 1600. Trident Z is a little bit better but ripsaw will do.

 

[lafiexs9]

either works, my ripsaw is running 3200 for my 1600. Trident Z is a little bit better but ripsaw will do.

Thank you.