Laptop graphics display problem

Status
Not open for further replies.
That looks like a hardware failure for sure to me. Either the RAM, CPU, motherboard or possibly the hard drive has failed. Are you getting any beep or led codes when you start the unit up?

Try running memtest and seatools for DOS, as a starting point.

Memtest: http://www.memtest.org/


Seatools for DOS: http://www.seagate.com/support/downloads/item/seatools-dos-master/


When you run Seatools, run the short drive self test and the long generic.
 

noctornus

Reputable
Sep 17, 2014
11
0
4,510
There are no beeps or led codes. It start the system and it is possible to control system but there are too much interference.
I downloaded the tools and prepared them but cannot set them to run, because I can not see whats going on, to much interference on the screen.
I will try to run this tools (will remember steps from other computer).
This is how screen looks like.
http://i1290.photobucket.com/albums/b523/noctornus/pcs1_zps2rit3xyn.jpg
http://i1290.photobucket.com/albums/b523/noctornus/pcs2_zpsxxpxygwa.jpg

Thank you a lot for helping me!!
 

noctornus

Reputable
Sep 17, 2014
11
0
4,510
I opened laptop, inspected heatsink and change thermal paste on CPU. When I put it together first boot it was same. I turned it off and I tried again after 15 minutes, it worked and not squares were showing. Now it's working normally, and I hope it will stay that way. Hope this will be helpfull for somebody.
Thanks darkbreeze for helping me.
 
Status
Not open for further replies.