Liquid not flowing properly [SOLVED]

Status
Not open for further replies.

doeree

Commendable
Jul 19, 2016
4
0
1,520
I recently built my first LC system and i am having problems with running liquid through the loop. In every tube that runs downhill there is only a tiny stream flowing. My pump isnt pulling any water to fill the huge air bubbles out of the res its attached to ( i have a combo)
 
Solution


Ok. I had a D5 Revo Pump from EK, wich is surely more than enough for a Graphics Card (Gtx 1080) , a Cpu and a big, 480mm Rad. I was building in the Thermaltale Core P5, wich is excellent for watercooling. When I filled it up there was always only a little stream of liquid flowing and it wasnt pulling out of the Res. My Loop is: Res - Pump - Cpu - Motherboard - Gpu - Rad - Res.

Im using the built in waterblock on the maximus formula VIII, and cpu blocks from ek.

I just tilted the case in all directions (even completely upside...

doeree

Commendable
Jul 19, 2016
4
0
1,520


Ok. I had a D5 Revo Pump from EK, wich is surely more than enough for a Graphics Card (Gtx 1080) , a Cpu and a big, 480mm Rad. I was building in the Thermaltale Core P5, wich is excellent for watercooling. When I filled it up there was always only a little stream of liquid flowing and it wasnt pulling out of the Res. My Loop is: Res - Pump - Cpu - Motherboard - Gpu - Rad - Res.

Im using the built in waterblock on the maximus formula VIII, and cpu blocks from ek.

I just tilted the case in all directions (even completely upside down) and refilled the res regularly. There was still a middle sized bubble in the gpu block but it dissappeared after about 3 days.
 
Solution
Status
Not open for further replies.