looking for 90-degree system panel jumper block

[Junkpants]

Greetings,
I have a situation where all (4) PCI slots on my mobo are filled with the same double-width GPU and the last GPU is physically blocking access to the system panel jumpers.
Does anyone make a reputable 90-degree jumper block?
So far, I have found this, but am not sure if it's the correct item or a legit vendor.

http://starconnect.en.made-in-china.com/product/HBDndUkVbWhE/China-2-54mm-90-Degree-Break-Away-Pin-Header-Female-Double-Row.html

Any help would be greatly appreciated!

thank you

 

[popatim]

The wires from the case will bend quite freely and be even lower then using that jumper block. IMO, you don't need anything extra.

 

[Junkpants]

The wires from the case will bend quite freely and be even lower then using that jumper block. IMO, you don't need anything extra.

so literally just bend the pins over? Hadn't thought of that....

 

[popatim]

no, don't bend the pins. Connect the front panel wiring to the pins and then bend the wires over; out of the way.

 

[Junkpants]

no, don't bend the pins. Connect the front panel wiring to the pins and then bend the wires over; out of the way.

the problem is even with the wires bent over it's too tall by +1/8", the GPU will not seat properly
It looks like the plastic connectors on each jumper could be trimmed quite a bit, but that's tedious and fussy work that I had hoped to avoid

 

[popatim]

Really? I have never run into that. I guess the 90 is the way to go for you.

 

[Junkpants]

solution: I used the jumper block that came with the mobo and bent those pins over instead. It just fit!