G
Guest
Guest
I set the jumpers on the hd's and installed them, when I boot my dvd doesn't run as it normally does and when it reaches boot time it displays the "no bootable data please insert disk .....". This will happen even after I remove the ide cable and power from the slave, until I remove the dual ide cable and run the system on a single ide cable.(I was running my system on the dual cable prior to this with the single master drive) I understand how to setup the drives in bios and which connector on the ide cables is the master and which is the slave.
Anyone have any idea...I sure don't.
Thanks to all whom reply.
Anyone have any idea...I sure don't.
Thanks to all whom reply.