Question Memory Install

[Legskeattch]

Hi there,

I’m install new memory into:

Gigabyte GA-H110M-S2H

I’m replacing

Patriot PSD48G240081 DDR4 8 GB 2400

with:

INTEGRAL IN4T16GNDLRI DDR4 16 GB 2400



My issue is that when replaced, I know have no signal on monitor. The computer boots as expected (1 beep, correct lights) but no signal.

To check if this was the new RAM being faulty, I replaced it with the old RAM. I have tried all combinations.

I have cleaned the RAM as show in many YT videos.

I have the same issue.

Assistance would be fantastic and appreciated.


Luke

 

[logainofhades]

Try a cmos reset.

 

[Legskeattch]

Just found the instructions to do it...

Used a screw driver to touch the two pins for 5 seconds.

I then removed the CMOS battery and replaced.

exact same. No signal.

 

[Legskeattch]

I have tried:

both sets of new and old ram in both ports singular and together.

no luck!