Mobo standoffs and Case compatibility?

[GarsBuild]

Hey folks, I have a Corsair CC-9011023-WW Carbide Series 200R Compact ATX and a Gigabyte b250m DS3h. The standoffs don't seem to be in the right position. Should the standoffs poke through the mobo holes? This is my first build so not sure if I'm doing something wrong

 

[clutchc]

No, the board should rest on the standoffs. Do you have JUST the standoffs required installed? Not any in un-needed holes. Maybe post a pic of the situation.

 

[mdd1963]

Sometimes one standoff in the center will poke thru, the rest line up for screws to insert/secure it down.....

 

[GarsBuild]

Yes, one head pokes through on the bottom right of the Mobo but the rest do not. Also, the head that pokes through is like a little nipple that I can't screw anything on. Here's the Motherboard, the little nipple thing is to the top right of the gigabyte: http://imgur.com/DCa17BD
Here's the case behind the mobo:
http://imgur.com/4hkvrpT

Are the two things that came (see below) supposed to go into the bottom holes?

Shouldn't the rest of the standoffs poke through? Do I need a washer or something for screwing the Mobo in place if not? Also these things came with the Mobo or the case (can't remember) but there are only two of them:
http://imgur.com/9nD95tN

Thanks for the help!

 

[clutchc]

Oh! That is the guide standoff. It is usually positioned more near the center of the board. It is used for holding the board in place after you've managed to get all the I/O ports in their respective holes at the back of the case. That is perfectly normal.

 

[GarsBuild]

THANK YOU. I'm rocketing through this build !!!