My motherboard has gone faulty?

[Mihawk09]

To make a long story short, i bought a new case. I placed all the parts in the new case and wanted to start but i didnt get a screen all i got is like 3-4 fast beeps and no screen. So i removed the ram and i heard the sound of a starting computer. The computer did actualy start but still no screen. So i tried the onboard gpu of the mobo and still no screen. So im geussing i need to buy a new mobo?

 

[scout_03]

your motherboard was working before so recheck the set up look it you did not put a stand off where it should not be also recheck for all the connector on the board and use minimal parts to start the system in the new case .

 

[Mihawk09]

your motherboard was working before so recheck the set up look it you did not put a stand off where it should not be also recheck for all the connector on the board and use minimal parts to start the system in the new case .

Oke i tried that but still didnt work, i hear the computer boot but no screen with my GPU and onboard GPU ( mobo ) both didnt gave a screen.

 

[scout_03]

check the memory module if they are well clip and the wire from the case if they are at the right connector on the board so see if the board do not make any contact to the case on the back where you plug the video card,do the led on the board receive power .

 

[Mihawk09]

check the memory module if they are well clip and the wire from the case if they are at the right connector on the board so see if the board do not make any contact to the case on the back where you plug the video card,do the led on the board receive power .

The led is on, the ram and the video card works. I tried to remove the components 1 for 1 and still no screen onboard or with my gpu

 

[scout_03]

when the monitor is on power does it give a no signal advice .

 

[Mihawk09]

when the monitor is on power does it give a no signal advice .

Yes it does.

 

[scout_03]

do you have another cable you could use for test between the monitor and pc .

 

[Mihawk09]

when the monitor is on power does it give a no signal advice .

Yes and when i turn it on it still says no signaal or it gives no screen

 

[scout_03]

well you will have to do the cardboard test ,take everything out of new case and try to start to see if you get video on the monitor .

 

[Mihawk09]

So with take out everything u mean take out the CPU ram gpu everything on it, taken it all out and only put the power cables in and than try if it gives a screen?. How am i gonna boot the motherboard with no power button?

 

[scout_03]

you could remove the board from the case with all the component on and use a cardboard under her to avoid contact with the case and in the motherboard user manual the tell you where the switch go momentary touch those 2 pins with a small flat scewdriver to start without the switch and see if you have video . that the most i could do without having the system on hand .

 

[Mihawk09]

you could remove the board from the case with all the component on and use a cardboard under her to avoid contact with the case and in the motherboard user manual the tell you where the switch go momentary touch those 2 pins with a small flat scewdriver to start without the switch and see if you have video . that the most i could do without having the system on hand .

Oke thank you im gonna try that.