Need help reading SMART results from hddscan

[ericman]

Whenever I open anything, it runs slow.. Its as if I am watching it at one quarter speed. After consulting a separate (old) thread, I was led to believe a SMART scan might be telling. Here are the results:
Model: Samsung SSD 850 EVO 500GB
Firmware: EMT01B6Q
Serial: S21HNSAG127523Z
LBA: 976773168

Report By: HDDScan for Windows version 3.3
Report Date: 4/3/2016 8:39:18 AM

Detected controller Unknown



Num Attribute Name Value Worst Raw(hex) Threshold

005 Initial Bad Blocks Count 100 100 0000000000-0000 010

009 Power-On Hours Count 099 099 0000000000-043F 000

012 Device Power Cycle Count 099 099 0000000000-015F 000

177 Wear Leveling Count 099 099 0000000000-0001 000

179 Used Rsvd Block Count Total 100 100 0000000000-0000 010

181 Program Fail Count Total 100 100 0000000000-0000 010

182 Erase Fail Count Total 100 100 0000000000-0000 010

183 Runtime Bad Block 100 099 0000000000-0000 010

187 Reported Uncorrectable Error 100 100 0000000000-0000 000

190 Unknown Attribute 066 057 0000000000-0022 000

195 ECC Rate 200 200 0000000000-0000 000

199 SATA R-Errors Count 100 100 0000000000-0000 000

235 Unknown Attribute 099 099 0000000000-0004 000

241 Total Host Writes 099 099 0000006D3A-7698 000

 

[Emerald]

Use the Samsung Magician Software to check the health status of your drive.