Need help to correct geometric distortion

[Guest]

Hello all,

I recently purchased a Mitsubishi DiamondView 19NF monitor. There is a noticable distortion at the top of the screen where the picture slants sideways towards the left. It doesn't affect the whole screen just the top 1 - 2 cm. I want to get the most out of my monitor. I have tried to manipulate some of the OSD controls for geometry but I have no idea what I am doing. Apart from the distortion problem the monitor performs reasonably well.

Can anyone help me? I bought the monitor and a few weeks later I found the guide for CRTs here. I wish I had look first before I bought 🙁.

regards,

Brainless

 

[Toejam31]

There's a link to the monitor manual on this <A HREF="http://www.mitsubishi-electric.com.au/downloads/monitors/manuals.htm" target="_new">page</A>, which might help you figure out the controls.

Have you installed the <A HREF="http://www.mitsubishi-electric.com.au/downloads/monitors/19_md.htm" target="_new">driver</A> for the monitor?

You might find this <A HREF="http://www.displaymate.com/" target="_new">utility</A> helpful for setting up and calibrating your display. It's not free, but it is an excellent product for this purpose.

Toejam31

<font color=red>My Rig:</font color=red> <A HREF="http://www.anandtech.com/mysystemrig.html?rigid=6847" target="_new"><font color=green>Toejam31's Tantalizing Tantric Toy</font color=green></A>
____________________________________________________________

<font color=purple>"Procrastination on your part does not constitute an emergency on my part."</font color=purple>