Question new build having big issue.

[onemoretimex]

Hey

Just recently installed a new mobo, new ram, New Psu and Apu.

All the parts were recommended and verified using part picker.

Was told to for my Processor to achieve its full potential not to buy ram any lower than 3000ghz with 3200ghz being the peak.

The issue I'm having is getting my Ram to go at 3200ghz... the motherboard says it can do it on the box and my ram sticks are 3200ghz.

However once I change the memory dram from auto to 3000ghz+ I lose all picture display and cant get it back on until I reset my motherboard by removing the battery.

here is the set up.

windows 10 64
ASRock B450M-HDV R4.0
Amd Ryzen 3 2200g
Corsair CMK16GX4M2B3200C16 Vengeance LPX 16 GB (2 x 8 GB) DDR4 3200 MHz
Corsair CP-9020102-UK CX550M 550 W 80+ Bronze Certified ATX Po Wer Supply Unit

 

[richiestang_78]

Are you enabling the XMP (sometimes listed as DOCP or EOCP, but I think ASRock just uses XMP) profile?

 

[onemoretimex]

Are you enabling the XMP (sometimes listed as DOCP or EOCP, but I think ASRock just uses XMP) profile?

I seen something above the part I changed that said XMP not sure if its enabled or not I just went straight to the part under it which says DRAM frequency and took it off auto and increased it one by one until i got no loading.

I will go check and leave it at auto to prevent not being able to load for 2 hours lol

 

[richiestang_78]

I seen something above the part I changed that said XMP not sure if its enabled or not I just went straight to the part under it which says DRAM frequency and took it off auto and increased it one by one until i got no loading.

I will go check and leave it at auto to prevent not being able to load for 2 hours lol

Try the XMP profile first.

 

[onemoretimex]

Try the XMP profile first.

So I changed the xmp from auto to I think it was profile 2.0 or something along those lines...
I left the dram frequency as auto

and checked im still at 2166ghz.

 

[onemoretimex]

So I changed the xmp from auto to I think it was profile 2.0 or something along those lines...
I left the dram frequency as auto

and checked im still at 2166ghz.

Also forgot to mention I have updated the motherboard bios as I was told it is ready out of the box for my Apu so wouldn't need to?