[SOLVED] New build shuts down when gaming and after stress testing ?

Jan 28, 2024
11
1
15
Specs:
Mobo: Gigabyte A620M DS3H
CPU: Ryzen 5 7600X
GPU: XFX 7900 XTX
RAM: 2 x 16GB Vengeance 6000 MHz (EXPO ON/OFF still turns off)
CPU Cooler: DeepCool AK620
PSU: Seasonic B12 850W 80 Plus Bronze

PC shuts down almost instantly after starting stress test from AIDA64 and FurMark. Could this be a defective PSU? It also happens when gaming… It just shuts down, no blue screen. Temps are fine, so it’s not overheating or anything like this. Please help thank you!

EDIT: I only had two cables to connect to the three 8-pins from the GPU, so i daisy chained one, hope thats not an issue.
 
Last edited by a moderator:
How old is your PSU? It is the likely source of the problem. That PSU uses an older design and doesn't meet the needs of high-end modern GPUs like your 7900 XTX. These GPUs are very demanding in terms of power requirements.
The PSU is around 3 months old, sat on a shelf until yesterday.
 
Understood. As stated earlier, the PSU is the likely issue regardless of its age.

A couple to consider:

(1000w): https://seasonic.com/atx3-focus-gx
https://www.corsair.com/us/en/p/psu...-fully-modular-atx-power-supply-cp-9020253-na
I just checked and the power button seems to stay on after the PC shuts down. Does this confirm the PSU theory? Thank you for the recommendations!
 
Try this to see what happens. Reach behind your system and flip the PSU power switch to off. Then press the power button to discharge residual power in the system (I know this sounds silly, but I'm serious). Next, flip that switch back on. Does the power switch LED illuminate?
 
Try this to see what happens. Reach behind your system and flip the PSU power switch to off. Then press the power button to discharge residual power in the system (I know this sounds silly, but I'm serious). Next, flip that switch back on. Does the power switch LED illuminate?
No, the LED stays off that way.
 
Last edited:
The new one had 3 separate PCIE cables, so maybe that helped too!
I'd say that was possibly the only problem; the GPU needs 355W, you get 75W from the slot leaving 280W, so the card was likely trying to draw about 90-100W through each power input meaning one of the PCIe outputs on your PSU was trying to supply ~200W causing the overload protection to kick in.
 
I'd say that was possibly the only problem; the GPU needs 355W, you get 75W from the slot leaving 280W, so the card was likely trying to draw about 90-100W through each power input meaning one of the PCIe outputs on your PSU was trying to supply ~200W causing the overload protection to kick in.
That would make sense. Thank you for the clarification.