[SOLVED] Pc powering on but no display

[Clutch_Noob]

I just built a pc with an i3 - 7100, h110 d3a mobo, 8 gb crucial ddr4 ram, maxsun nvidia 1050ti 4 gb, and an old 500 watt power supply from 4 years ago. All of the components used. It powers on, no beeping. Fans power on as well. Initially nothing showed, turned out the 1050ti needs a 6 pin pci e so I used a different power supply and turned it on after turning on the other one as not risk any damage. Still nothing showed. Tried a 750ti, nothing showed as well. I dont know if it's a bios issue or what, theres no signs of any issue other than the fact that there is no image.

 

[boju]

Most likely the bios needs an update.

https://ie.pcpartpicker.com/list/#problems

Some Intel H110 chipset motherboards may need a BIOS update prior to using Kaby Lake-S CPUs. Upgrading the BIOS may require a different CPU that is supported by older BIOS revisions.

 

[Clutch_Noob]

Are you sure about that? I had a g3900 but just sold it. I found a g3930, would that work? I read something about gigabyte motherboards being able to start it up alone as well. I have no clue what yo do ti be honest

 

[boju]

What bios revision does your board have?

Is this your board?

https://www.gigabyte.com/Motherboard/GA-H110-D3A-rev-10#support-cpu

If it's F20, i3 7100 should be working. If F1 then need to update with one of the Skylake cpu's. g3930 is kabylake requiring F20 to work same as 7100.

I read something about gigabyte motherboards being able to start it up alone as well

Do you mean updating bios without a cpu? Few highend boards support that but not this board.