I have recently installed new gpu to my system.
Specs:
Cpu: i3 10100f
MB: msi h410m A-pro
Gpu: gigabyte 1050 ti (1455 cores, this one does not required any external power)
Ram: adata gammix d30 8gb
Psu: Coller master 550w bronze
Ssd 240gb and hdd
Except for gpu everything under warranty
After installing gpu, my pc under under load restarts without warning.
Direct off then auto boots in next 2 secs.
My temperatures are normal and even there is no fps or performance issues with gpu. I haven't tried it in different pc as i don't have one.
If playing games or disk search or under load this happens.I have stress test gpu with unigine and it works good with good fps but after few minutes or sometimes direct pc restarts.
My psu is 550w and pc requires ~300-350w and gpu max takes 75w as of manufacture site.
I was also having some issue with my MB some time back.
It says " Over current detected at usb ports " And would not boot or starts, but it started working after kept without use for 2 days and after that i have been using only my usb 3.0 ports and trying not to use 2.0 ports much.
Specs:
Cpu: i3 10100f
MB: msi h410m A-pro
Gpu: gigabyte 1050 ti (1455 cores, this one does not required any external power)
Ram: adata gammix d30 8gb
Psu: Coller master 550w bronze
Ssd 240gb and hdd
Except for gpu everything under warranty
After installing gpu, my pc under under load restarts without warning.
Direct off then auto boots in next 2 secs.
My temperatures are normal and even there is no fps or performance issues with gpu. I haven't tried it in different pc as i don't have one.
If playing games or disk search or under load this happens.I have stress test gpu with unigine and it works good with good fps but after few minutes or sometimes direct pc restarts.
My psu is 550w and pc requires ~300-350w and gpu max takes 75w as of manufacture site.
I was also having some issue with my MB some time back.
It says " Over current detected at usb ports " And would not boot or starts, but it started working after kept without use for 2 days and after that i have been using only my usb 3.0 ports and trying not to use 2.0 ports much.
Last edited: