Question PC won’t work after interrupting mflash

Jul 2, 2020
1
0
10
0
Hello, I just selected m-flash on the bios of my Tomahawk and then the pc turned off and then on again, but this time all of the devices I had set up via usb wouldn’t light up. I waited a little bit and then decided to try turning my PC off and on again. Same exact issue and the monitor won’t even connect to the pc and I can’t see anything. What do I do?
 

egda23

Prominent
Jun 14, 2020
715
126
640
23
Hello, I just selected m-flash on the bios of my Tomahawk and then the pc turned off and then on again, but this time all of the devices I had set up via usb wouldn’t light up. I waited a little bit and then decided to try turning my PC off and on again. Same exact issue and the monitor won’t even connect to the pc and I can’t see anything. What do I do?
Disconnect the PC from electricity, remove the CMOS cell battery. Wait 15 min. Put everything back in place. Try to boot
 
Last edited:

ASK THE COMMUNITY

TRENDING THREADS