Power Surge after intsall of gtx 1060 with 500W PSU???

[Michael2211]

After I Installed my new graphics card the gtx 1060 in my rig, replaced 750 ti sc, I started to notice a few things after boot.

One after I turned my computer asleep and woke it, the hardware and lights of the pc would turn on but I would not receive a display. I have to hard reset it every time or just shut down from windows.

Second I now receive lag spikes even though I receive 60+ fps maxing out all triple A titles. Every couple of minutes my fps drops from 60 to 25 and lasts for a couple of seconds ranging from 5 to 25 seconds. Really annoying!

Third I noticed when rebooting I received a message saying Bios detected a power surge. Though I believe a 500W PSU should be enough to run my system.

Specs:
GPU: PNY GeForce GTX 1060 6GB (Had a evga 750 ti sc before updating)
CPU: AMD FX 8350 Black Edition
CPU COOLER: Cooler Master hyper 212
MOBO: ASUS Micro ATX M5A78L-M/USB3
RAM: Kingston HyperX Fury 8GB Kit (2x4GB) 1866MHz DDR3
PSU: EVGA 500W 80 PLUS Certified ATX12V/EPS12V
CASE: Corsair 100R ATX Mid Tower Case
CASE FANS: Corsair Air Series AF120 Quiet Edition (2-Pack)
STORAGE: Crucial BX200 240GB 2.5" Solid State Drive, as well as 500GB at 5400 rpm (3.5")

I don't know if I have a faulty PSU or Graphics card. Could someone please help me? Thank you

Contact info: 4167218208

 

[Jobble_Gobble]

A power surge shouldn't have caused any of those previously mentioned issues, but for sure get a surge protector so you do not fry any of your parts. Also EVGA do have some dodgy under and over voltage protection on some of their cheaper Power Supplies.

 

[MeanMachine41]

Two things to consider Michael as your PSU may indeed be failing.
Stress test your system under full load and observe Rail voltages 12V, 5V, 3.3V. You can use HWMonitor for this.
Swap out the PSU with a known working unit of same or higher Wattage.

IF PSU tests OK then, you always have the option of turning power surge protection off in Bios.

IMO the PSU is not doing its job and is borderline Wattage wise for your setup.

 

[Michael2211]

So I have a screen shoot of HW Monitor while stress testing my system. I think the rail voltages are ok but I'm not sure, new to this. Also cant seem to paste picture so I'm hoping either MeanMachine41 or Jobble_Gobble
can give me their emails so I can send it to you. Thanks again

 

[MeanMachine41]

So I have a screen shoot of HW Monitor while stress testing my system. I think the rail voltages are ok but I'm not sure, new to this. Also cant seem to paste picture so I'm hoping either MeanMachine41 or Jobble_Gobble
can give me their emails so I can send it to you. Thanks again

To post a link to your screen shot, Use IMIGUR as a file host. Upload the file to IMIGUR, select Images and copy the BBurl then link it here for analysis.

 

[rcald2000]

+Michael2211 This is the last thing that you're concerned about at this moment, BUT this is the only surge suppressor that I buy (below). I have four of these installed around my place and I highly recommend it. The $20 is worth the piece of mind. The advice that you're already receiving on your actual issue is solid.

BELKIN BE112230-08 8 Feet 12 Outlets 3780 Joules Surge Protector with Telephone and Coaxial Protection
$18.60
http://www.newegg.com/Product/Product.aspx?Item=N82E16812107196

 

[Jobble_Gobble]

Here you are http://imgur.com/Y9rpSUo
The 12V rail isn't anywhere near 12V, same goes for the rest.

 

[MeanMachine41]

Here you are http://imgur.com/Y9rpSUo
The 12V rail isn't anywhere near 12V, same goes for the rest.

Yes your quite correct Michael, All Rail Voltages our well out of acceptable spec.
Do not continue to use your system till you swap out the PSU.

 

[Michael2211]

Thank you guys so much!! Would you happen to have a power supply recommendation for my system? Thanks again!!!

 

[rcald2000]

Ironically, I would normally recommend a EVGA power supply, although a higher reliability unit than the one you previously purchased. Since you've probably had your fill of the brand for the moment, then I recommend the one below. It has bronze power efficiency but it is not modular; all the cables are permanently connected to the PSU. While you're in the buying mood, you might as well add that surge suppressor to cart while you're at it.

SeaSonic S12II 520
$54.99
http://www.newegg.com/Product/Product.aspx?Item=N82E16817151094&ignorebbr=1&cm_re=seasonic_s12ii-_-17-151-094-_-Product

BELKIN BE112230-08 8 Feet 12 Outlets 3780 Joules Surge Protector with Telephone and Coaxial Protection
$18.60
http://www.newegg.com/Product/Product.aspx?Item=N82E16812107196

 

[MeanMachine41]

Thank you guys so much!! Would you happen to have a power supply recommendation for my system? Thanks again!!!

Quality brands are EVGA , Seasonic, Antec and Corsair however, I recommend a Gold certified unit for efficiency and 650-750W if you intend to OC the CPU or expand in the future. Bronze rated units are for budget buyers and generic PCs that don't demand a decent quality or efficient PSU.