Problem connecting my RGB LEDs in the P7-C1 case

Bros4Lyf

Reputable
Jul 23, 2015
3
0
4,510
First time PC builder and so far I have everything plugged in except for the two 4-pin RGB LED cables that come with the case.

Image here of the cables mentioned: http://

At the bottom of http:// it says that they should be powered by molex connectors but I don't see anything from my PSU that would fit together with them.

What I'm thinking is that my PSU don't have the necessary connectors and I will need to buy a new PSU (or just ignore the cables all together) or there is another way of connecting these that I don't know of.


Any info is very much appreciated since this is my very first build :)


Components:

  • ASUS Prime Z370-A Motherboard
    Aerocool P7-C1 Tempered Glass Case
    Corsair CX550 W PSU

If there is any more I need to mention, do tell :)


 
Solution
In the review you linked, it's said that you need to connect the molex connector to your PSU to power the LEDs while the other 2x 4-pin RGB connectors are for expanding LED solution.
molex:
innercableledpower.jpg

The image you linked before review shows the 2x 4-pin RGB connectors and not molex connector. So, if you don't plan to add additional LED strips to your setup, those 2x 4-pin RGB connectors remain unplugged.

Aeacus

Titan
Ambassador
In the review you linked, it's said that you need to connect the molex connector to your PSU to power the LEDs while the other 2x 4-pin RGB connectors are for expanding LED solution.
molex:
innercableledpower.jpg

The image you linked before review shows the 2x 4-pin RGB connectors and not molex connector. So, if you don't plan to add additional LED strips to your setup, those 2x 4-pin RGB connectors remain unplugged.
 
Solution