Time to put on yo thinkin caps, foo.Let's try to keep this short. Long story short, someone, somewhere decided that they didn't like me vey much and cursed me. I broke the sata data connector on my seagate drive so after an inadequate amount of research I ordered a new pcb. The serial on the original board is 100574451 rev b. I ordered the same one, and was told that the revision didn't matter on this board. The one I got said rev a. I installed it and the drive is getting power (good) but just making clicking sounds. Being detected, but not showing up in the file browser. now all I have to do is get the bios chip swapped.
Here's where my question comes in. I found (the internets told me) that there's specific information on the platters and that's why pcb swaps don't really work. I didn't exactly want to hear this. I spent most of my money on this board (angry young and poor here) my questions are does the revision matter, and will this work at all due to some of the information being on the platters? I'd rafter not blow the rest of my money paying some guy to swap the bios chip to have it not work. I eagerly await and appreciate all responses.
Here's where my question comes in. I found (the internets told me) that there's specific information on the platters and that's why pcb swaps don't really work. I didn't exactly want to hear this. I spent most of my money on this board (angry young and poor here) my questions are does the revision matter, and will this work at all due to some of the information being on the platters? I'd rafter not blow the rest of my money paying some guy to swap the bios chip to have it not work. I eagerly await and appreciate all responses.