Radiator setup Push/Pull

[Joey Perez]

So I would change my front exhaust to intake, Should I do a push config or pull?. Pull is infront of the rad near the motherboard? and Push is in the mounting bracket of the radiator?
Thanks!

 

[Joey Perez]

I`m using an 400c case, h110i gtx AIO in front exhaust , 1 140mm top exhaust , 1 120mm rear exhaust, Should I change my front to intake and in a pull config? or push config?

 

[Joey Perez]

I`m using an 400c case, h110i gtx AIO in front exhaust , 1 140mm top exhaust , 1 120mm rear exhaust, Should I change my front to intake and in a pull config? or push config?

 

[th3p00r]

Push means the fan blows the air onto the radiator and pull means the fan pulls the air from the radiator. You can use pull and mount the fan so that the hot air blows outside of the case like the power supply via case fan mount area. Better if you can have both.

 

[MWP0004]

Ideally, you want air flowing through the case. Having all of the fans only in exhaust does not provide much through-flowing air.

 

[ahnilated]

You want the front, side, bottom to be intakes, the top and back to be exhaust. This has been discussed to death on this site.