replacing side fan

[iVassh]

I have an armor revo full case, I want to replace the 200mm side fan with one that has led lights in it, my question is the fan on my case right now uses these connections.

The top picture is whats attached to the side panel and runs to the fan, the bottom picture is on the case and runs to the case's high/low switch

is there any way to replace the fan and use that same connection? I know I can easily use a 3 or 4 molex plug. I don't want that, I want to use this connection, any way to do it? or does the fan I buy need to come with this connector?

 

[ThomasJ93]

Only way to use the same connection is by removing the connector from the new fan and solder the wires to these pins. Just check what pinout it uses and make sure to solder it correctly.

 

[iVassh]

Only way to use the same connection is by removing the connector from the new fan and solder the wires to these pins. Just check what pinout it uses and make sure to solder it correctly.

aww I was afraid someone would say that. dont have a soldering iron and only soldering skills I have are from a 10th grade engineering class ....

 

[ThomasJ93]

soldering 3 wires isn't as hard as it sounds. It's a problem if you don't have a soldering iron though.

Only other way to replace the fan would be not using this connection.