[SOLVED] safe voltage for ryzen 3 1200?

[NightHawkRMX]

I currently have an AMD ryzen 3 1200 and a msi b350 gaming + motherboard. I am trying to get 4.0ghz just long enough to run cpuz validator and get a banner. My system will crash on windows login screen at 1.435 volts and when i try to enter more, the value turns red. Is 1.475 volts unsafe for a minute or 2? How far can i go? I cant get past login screen at 1.45 volts

 

[NightHawkRMX]

https://www.reddit.com/r/Amd/comments/5y3lls/safe_voltages_for_ryzen/ i have seen this thread. It says under 1.55 for a burst.

 

[scout_03]

if you did read it to the end most of then use 1700 or 1800 hundred one cpu so not shure the 1200 would be able to handle this .

 

[NightHawkRMX]

They are all basically the same die, just with disabled cores. I didnt bump it past 1.5 volts even though it is not stable enough at 4.0. It freezes at the desktop.

 

[scout_03]

look like it is on the limit could not do more then wish you luck .

 

[NightHawkRMX]

Yup. I dont wanna kill my mobo or chip. I think ill set it back to my previous setup. 1.275 volts at 3.7ghz

 

[scout_03]

on default settings of it on volages did you activate the axmp for ram you should gain 200 mgz in speed .

 

[NightHawkRMX]

I have my 3200 kit set manually to 3333mhz with auto voltage

 

[scout_03]

do they have same jedec settings on manual at axmp with same voltages then your good .

 

[NightHawkRMX]

I think they have the same settings. I didnt enable xmp but i did set the frequency to 3333mhz. No other voltages or timings have been changed

 

[scout_03]

the use cpu-z spd tab and compare with the memory tab of the same software if they are similar aand the other thing you could try is to put axmp on and see if they both give same speed or one is faster keep this one for settings .