Same monitors but all different height?

[torx11]

I just finished setting up my three monitor setup and I noticed that all three of them are different height when they are side by site on their included stand. The table they are on is completely flat by the way with no tilt to it.

I have pushed all three monitors down into their base until there was a clicking sound.

The variation in height are around 0.2 to 0.5 inches. Could this be a manufacturing issue? The monitors I have is this.

 

[scout_03]

they all have same model number did you check the manufacturing date and from where i would put the taller in middle and the others on the side .

 

[torx11]

they all have same model number did you check the manufacturing date and from where i would put the taller in middle and the others on the side .

Thanks for the answer scout_03. They are all manufactured in China but on different months. One is April 2016, September 2016, and October 2016.

I'm left scratching my head because wouldn't they be using some sort of cast in order to create exact replications of each model?

 

[Solandri]

I'm left scratching my head because wouldn't they be using some sort of cast in order to create exact replications of each model?

Yeah, the length of the stand should be the same between all three monitors.

I assume you're comparing edge-to-edge height? i.e. the right side of one monitor to the left side of the adjacent monitor. Are they all level? A slight tilt in the screen could easily account for a 0.2-0.5 inch difference in height. These stands are supposed to hold the monitor perfectly level, but I've found they rarely do (the left side of the screen will be at a slightly different height than the right side).

 

[torx11]

I'm left scratching my head because wouldn't they be using some sort of cast in order to create exact replications of each model?

Yeah, the length of the stand should be the same between all three monitors.

I assume you're comparing edge-to-edge height? i.e. the right side of one monitor to the left side of the adjacent monitor. Are they all level? A slight tilt in the screen could easily account for a 0.2-0.5 inch difference in height. These stands are supposed to hold the monitor perfectly level, but I've found they rarely do (the left side of the screen will be at a slightly different height than the right side).

Yes I am comparing them edge-to-edge. Even if I tilt them all the way down or up the screens still remain at different height. The screen itself are all the same size though so maybe a solution to this would be to either wall mount them or have a third party stand mount for them.

 

[scout_03]

if you look at a 3 monitor stand give a look at these https://www.amazon.com/s/ref=nb_sb_ss_i_4_7?url=search-alias%3Delectronics&field-keywords=triple+monitor+stand&sprefix=triple+%2Celectronics%2C196&crid=W05VYS32JAG4&rh=n%3A172282%2Ck%3Atriple+monitor+stand