Question Stuck in Setup

[chobe]

Problems started with Dram and GPU fail or not detected on MB status LED's, no DP signal from your device...", system would not recognized USB drive for OS installation, all resolved by bios flash (Thank you Lutfij!). Now trying to complete setup and stuck on "Let's get you connected....". Other posts suggest Bringing up DOS prompt, using Win+R to install network driver, verifying valid network connection, etc. All or which are unable. There is NO response from keyboard as if not connected or system frozen. Connection is valid (same connection from router to this PC, keyboard worked thru prior setup steps, Shutdown restarts setup and gets stuck at same spot.

Any suggestions would be greatly appreciated!

 

[Lutfij]

Thank you for the shout out, kind sir!

Where did you source the installer for your OS? Have you tried recreating said installer to rule out a corrupt installer? As for the OS install, you should look into installing the OS in offline mode;

View: https://www.youtube.com/shorts/_GuFH9KdHC0


Have you tried hooking the keyboard/mouse over to another USB ports on the motherboard?

 

[chobe]

Interesting.....Had to swap port for keyboard which then allowed me to bring up command prompt, but had to switch back to original port to actually type anything.! But switch ports worked! Thanks again Lutfij