My house has a built-in surround sound setup. Well, it would if they had included a center channel. It’s technically just multi-channel stereo with a subwoofer right now.
The subwoofer is passive. I’m trying to use a Rockville RPA5 as the amp, but it’s not receiving any signal from the receiver (Denon avr-s540bt).
I’m using an RCA mono plug from receiver (Pre-amp 1) to amp (channel A). The amp is set to crossover mode and bridge mode. The receiver has the subwoofer setting set to “yes.” The other speakers are set to small.
As far as I’m aware, that’s all how it should be setup. But there isn’t any signal going from receiver to amp. Any ideas?
The subwoofer is passive. I’m trying to use a Rockville RPA5 as the amp, but it’s not receiving any signal from the receiver (Denon avr-s540bt).
I’m using an RCA mono plug from receiver (Pre-amp 1) to amp (channel A). The amp is set to crossover mode and bridge mode. The receiver has the subwoofer setting set to “yes.” The other speakers are set to small.
As far as I’m aware, that’s all how it should be setup. But there isn’t any signal going from receiver to amp. Any ideas?