Hi there,
I've been connecting two routers together, a NetComm NF4Vas master and a TP Link
IP Master: 192.168.1.1 (DHCP limited to .5 upwards)
IP Slave: 192.168.1.2 (DHCP turned off)
Everything is working fine between these too.
The problem comes in when we use a NetGear EX6200 as wireless access point (for it's 5g capability).
When this is included in the chain, I am unable to connect more than one device to the slave router through wifi.
Current setup is
Master -> NetGear wireless
Master -> TP Link slave
Also tested has been running the
Master - > NetGear wireles -> Slave
Any ideas / suggestions ?
I've been connecting two routers together, a NetComm NF4Vas master and a TP Link
IP Master: 192.168.1.1 (DHCP limited to .5 upwards)
IP Slave: 192.168.1.2 (DHCP turned off)
Everything is working fine between these too.
The problem comes in when we use a NetGear EX6200 as wireless access point (for it's 5g capability).
When this is included in the chain, I am unable to connect more than one device to the slave router through wifi.
Current setup is
Master -> NetGear wireless
Master -> TP Link slave
Also tested has been running the
Master - > NetGear wireles -> Slave
Any ideas / suggestions ?