Question Typical no display, did everything pc

[boldihevizi]

Hello guys!

I just happened to get some older Ryzen parts. I did test all of them in my pc, one by one and they worked flawlessly.
Now the problem is, I get no display w them if I put all of the together.

Specs:
-Asus Prime A320M-k (I know its a bad mobo, I sadly have the same one)
-R5 2600
-Corsair 2x4Gb 3000mhz ram
-Asus Gtx 1060
-Thermaltake Smart BM2 550w / CM Masterwatt Lite 400w
-Zalman s4 case
-Kingston A400 256Gb x2

Did cmos reset 3 times, tried reseating the RAM, no cables are loose, got a new PSU (prev was CM 400w) bc I tought 30A is not enough for a Ryzen, switched cases and tested w/out one and none seemed to work.
Also tried multiple Rams (they are all tested and work in my system), and cleaning the ram ports and sticks.
No display on DP or HDMI.
The PSUs can power an i7-3770 system with higher TDP…
No USBs connected (not even mouse or keyboard.
I’m kinda lost bc there are no led indicators and I couldn’t get display to turn on for a sec.
(Also the bios is up to date, I did update it with a 1st gen Ryzen).

Any ideas?

 

[Burbli]

Your mobo could be shorting out due to some bracket or screw that shouldnt be there. It can also be that your PSU is to weak. The minimum is 600w for a pc with ryzen cpus 500w is not alot. Also try taking out your mobo and place it on a cardboard box to see if it works.

 

[Burbli]

You should also check if the PSU is fine with a paper clip test, just yt what it is. Also check your ram, in most cases its ram. Place it in A2 and B2. Then place it in A1 and B2 if previous step dint work. Last option is single stick on A2 and later B2.