Hey all,
I have had about a few days to work on the new custom loop and from what I have seen so far Ive got a few concerns. The photo attached is the current configuration: http://i63.tinypic.com/2rz8h0g.jpg
Current Hardware:
Gigabyte X399 Designare
AMD Threadripper 1950x
Corsair Vengeance Pro (32gb)
Dual GTX 980's
Corsair RM1000 PSU
2 XSPC 360 Rads
2 XSPC GTX 980 blocks
XSPC D5 Photon res/pump combo
XSPC Raystorm Neo CPU block
Be Quiet 801 Case
So the biggest concern is our good old friend Temperature. Inside the case it gets to about 32c under load. CPU and GPU temps according to the corsair software are pretty solid at about 66c. I don't have my flow and temp meter in just yet so I can't give you an accurate temp on the coolant. With all of that said those temps seem pretty high with this configuration. Unfortunately with the design of the case there isn't really any other way to setup a push/pull on the rads, nor is there a way to get the access heat out of the inside of the case without taking the side panel off. So I really have 2 questions:
1: Should there be any concern with the temperatures listed?
2: Aside from a new case to open up options for airflow, is there another method of configuring this setup that I may have missed?
Thanks in advance!
I have had about a few days to work on the new custom loop and from what I have seen so far Ive got a few concerns. The photo attached is the current configuration: http://i63.tinypic.com/2rz8h0g.jpg
Current Hardware:
Gigabyte X399 Designare
AMD Threadripper 1950x
Corsair Vengeance Pro (32gb)
Dual GTX 980's
Corsair RM1000 PSU
2 XSPC 360 Rads
2 XSPC GTX 980 blocks
XSPC D5 Photon res/pump combo
XSPC Raystorm Neo CPU block
Be Quiet 801 Case
So the biggest concern is our good old friend Temperature. Inside the case it gets to about 32c under load. CPU and GPU temps according to the corsair software are pretty solid at about 66c. I don't have my flow and temp meter in just yet so I can't give you an accurate temp on the coolant. With all of that said those temps seem pretty high with this configuration. Unfortunately with the design of the case there isn't really any other way to setup a push/pull on the rads, nor is there a way to get the access heat out of the inside of the case without taking the side panel off. So I really have 2 questions:
1: Should there be any concern with the temperatures listed?
2: Aside from a new case to open up options for airflow, is there another method of configuring this setup that I may have missed?
Thanks in advance!