I bought a DTX case on special a couple months ago for the motherboard I bought some months before (that I never opened), which I thought was DTX; and it turns out the case is ~1/2" too small for it. I had a small--very--old case that I bashed the card slots out and cut the frame a bit for the motherboard rear ports to fit. The very old motherboard in it didn't have a modern form factor so it's spacers doesn't align with the one I'd like to install.
I have to make threaded holes for the motherboard spacers and I'm wondering which thread tap to buy. Anyone knows of the spacer screwing part specifications so I can tap the case frame?
Thank you kindly
I have to make threaded holes for the motherboard spacers and I'm wondering which thread tap to buy. Anyone knows of the spacer screwing part specifications so I can tap the case frame?
Thank you kindly