Worried about Intel Extreme Tuning, i5 4690k (first time OCer)

[Duncansoon]

i5 4690k
H212 Evo cooler

I recently built my second machine and couldn't wait to overclock, did some brief reading and tried to understand my CPU before doing so. I could use some reassurance or advice on my current Overclock settings as i'm pretty scared!
Below is the current overclock that i am using

http://imgur.com/0CXBduO



I ran a stress test using prime95 for about 30 mins and the temps i reached were averaging around 70-74 Degrees (maxed at like 80 for a brief second).

I also ran some games and the temp seemed to max at .
She also idles at around 30+

Are there any settings (shown in the picture) that are deadly and dumb?

Also is there anything i should do regarding power management settings i have it on power saver mode atm.

Thanks for your time,


Duncan

 

[DarkTerbear]

I would check on that memory multiplier on 14x
Do you have 1400MHz memory
:3

 

[Tradesman1]

Prob be better off OCing via the BIOS it looks like your at 4.1 and 1.2 is high for that minimal of an OC. Most of these software OC programs overvolt and you don't get the performance you could from going into the BIOS

 

[bicycle_repair_man]

Tradesman1 is bang on.

Overclocking via the BIOS will also give you control over power-saving features, some of which will negatively affect the overclock. You can also be more certain of system stability as the overclock will be applied at startup rather than when the OS has booted.

 

[Duncansoon]

Prob be better off OCing via the BIOS it looks like your at 4.1 and 1.2 is high for that minimal of an OC. Most of these software OC programs overvolt and you don't get the performance you could from going into the BIOS

Thanks for the reply,
i wasn't as confident doing it via the BIOS as there were many menu's i didn't understand, i will give it a shot when i get back from work. need to figure out how to set it back to default clock now!

 

[Duncansoon]

I would check on that memory multiplier on 14x
Do you have 1400MHz memory
:3

I have 8gb HyperX 1866MHz

 

[Duncansoon]

Well, i reset the settings back to default,and now when i reboot my computer wont reach the BIOS.
I narrowed this down to the keyboard being plugged in, very strange.

anyway i logged into the bios and this is my screen any help on what voltage and multiplier to do would be much appreciated, and any other setting i should add? also, i seem to be getting higher temps now im back at stock speeds.

1
http://puu.sh/mEABi/c573c31857.jpg
2
http://puu.sh/mEACg/93e99a4707.jpg

Thanks again.