[Updated] I use this system to simulate on Ansys HFSS.
[Updated1] Problem solved. Please read post #14
Hi everyone,
I'm building a system using dual xeon platium 8280. Everything works well until I run my task. It seem that the two CPUs can not work in parallel, you can see in picture below, only 1 CPU works when I do my task.
I try to set number of processor in system configuration to 56 cores but when my computer restart, it only shows 1 CPU with 28 cores.
image image
Here is my main board
image image
Please help me. Thanks a lot.
[Updated1] Problem solved. Please read post #14
Hi everyone,
I'm building a system using dual xeon platium 8280. Everything works well until I run my task. It seem that the two CPUs can not work in parallel, you can see in picture below, only 1 CPU works when I do my task.
I try to set number of processor in system configuration to 56 cores but when my computer restart, it only shows 1 CPU with 28 cores.
image image
Here is my main board
image image
Please help me. Thanks a lot.
Last edited: