Recent content by adnan_16a2

My local service provider upgraded the existing Cat5e wiring to Fiber optic, and turned my old 2750U into an extender. Now the speed is 90Mbps+ considering the ports are Fast Ethernet and not Gigabit. When I plug the Fiber optic router directly though, I'm easily getting 101.xx Mbps. I'll have...

I'm connected to the Internet through the WAN (the router has middle east firmware flashed which converts Ethernet port #4 into WAN port, disabling the DSL), and I did check the internet speed using both Wi-Fi and LAN. The result is the same on both. I don't get this part. The Ethernet port #4...

I recently upgraded from 5Mbps to 100Mbps, and observed that I'm not getting the speed that I opted for. The download rate is always stuck at 25-30Mbps and upload at 30-32Mbps. The router I'm using is D-Link 2750U which I bought in year 2014. It is an N300 ADSL2+ router which supports only...

The household voltage level in India is 220-240 volts. Do you think this PSU will encounter the problem you mentioned?

Are these the coils you looking for? I took it from the PSU. On the Linustechtips site, the one I intended to buy is listed as tier-2, and the one I received is tier-3 (both of them are to avoid because of coil whine, but I don't hear any). IDK how 230V one is different from non 230V one. The...

I ordered Cooler Master MPE-5501-ACAAB but dealer sent me MPE-5501-ACABW-B (Cooler Master MWE 550 V2 230V Bronze) instead. Now looking at Cooler Master's website, they say this one's DC-DC + LLC too, but when I'm looking inside the actual PSU, I don't see any daughter board or such. So, I'm...

it's either those two, or Corsair CV450. Not much of a choice.

I found another PSU. Antec NeoEco NE550M V2 modular. Is it any better than the gigabyte one?

I can't seem to find any reviews on this PSU (Gigabyte P450B), just that it's 80+ bronze certified. Anyone knows what is the OEM, and whether is it good PSU? Thank you. My PC: 240GB SSD GTX 1650 GDDR6 8GB DDR4 3000MHz 1TB HDD Either i5 9400F or R5 3500, whichever is cheaper.

That didn't work.

The system config is: Ryzen 3600 16GB ADATA XPG 3000MHz RAM ASRock A320M-HDV Motherboard WD Green SSD 240GB WD Blue HDD 1TB Zotac GTX 1060 3GB Corsair CX550 550W The problem is, when I shutdown the PC, and then start it, it'll boot up just fine. But if I restart it, there will be no display, no...

My build is Ryzen 5 3600 AsRock A320M-HDV 16GB RAM 1 HDD, 1 SSD Zotac GTX1060 3GB Budget is around $666 (bad omen?) Given current availability here (India), I can shortlist only 3 PSUs: Antec VP500PC, Antec NE 550M, and Corsair CX550 . I also have CX450 but I have my doubt there'll be very less...

Thanks for the hard work and the effort you put in this. There are some Deepcool PSUs out too. Please add them in the list too.

What is your budget for CPU, if you're upgrading it? Also Gigabyte recommends 650W for the GPU. You'd be better off building your own rig rather than buy and upgrade that (just watch one or two YouTube videos on building a PC)

Testing with Cinebench R20. With stock Intel cooler: With CM Hyper 410R: