Recent content by Blanned

Thank you for replying! IPv6 is and has been disabled

Hi, I suddenly lost the ability to access certain websites, that otherwise load perfectly fine when using cellular data on my phone. I think I am starting to see a pattern here and it could be some that are related to Microsoft. This issue happens on every browser, and every device connected...

Already fixed it by enabling ErP in the bios, it was disabled by default.

Hi, So I just built a new pc and I noticed that my PC Case fans (not my radiator ones) and psu fan keep spinning after full shutdown. I've waited a while to see if they do eventually shut off but they don't :/. I have tried disabling fast boot, hibernation, checked bios and set everything to...

Hi, So I just built a new pc and I noticed that my PC Case fans (not my radiator ones) and psu fan keep spinning after full shutdown. I've waited a while to see if they do eventually shut off but they don't :/. I have tried disabling fast boot, hibernation, checked bios and set everything to...

Hi, So I just built a new pc and I noticed that my PC Case fans (not my radiator ones) and psu fan keep spinning after full shutdown. I've waited a while to see if they do eventually shut off but they don't :/. I have tried disabling fast boot, hibernation, checked bios and set everything to...

So I've tried limiting PL1 and PL2 to 200W, which lowered my cpu to 78ºC under full load, however it downclocks on the P cores to around 4,8ghz. Is there any way to keep them at 5.0 or 5.1ghz?

Yup, I did

Hey guys, So I was trying to get resizable bar enabled on my pc, but I can't so I figured I could ask here. I've already updated to the latest BIOS and vBIOS, enabled resizable bar and 4G decoding in the bios aswell, and it still says that it's not on in nvidia's control panel. I'm running...

Hey, Thanks for answering! I'd love to set the power limit to 210 W ish and lower the clocks to 5.1GHz with a slight negative offset undervolt. I don't like my cpu being as high as 100ºC under full load, so achieving 85ish ºC in exchange of some slight performance, would make me feel relieved...

Hi guys, So I've been doing some testing and it seems that my cpu reaches 100ºC under 100% load on cinebench using a 240ml AIO. I watched JTC's video on underclocking intel and managed to get it to 1.115 V (static) and 5.1Ghz (I don't need it at 5.3-5.4) using Intel's XTU and it was running at...

Well I just contacted Cooler Master themselves and basically told me that the pump is dead and I need to replace it. Thanks for the answers :)

Hi, I’ve set the two headers to PWM mode and then saving and rebooting, but same issue even after switching the headers. At this point I’m starting to believe the pump is dead. View: https://imgur.com/a/dhfFslp here you can see the settings in the bios. thanks anyway

Hi, Thank you for your reply! Regarding #1, my motherboard has only a CPU_OPT that’s located on the top right next to CPU-FAN. At the bottom, it also has a SYSfan1_PUMP header, which I also tried to connect to, but it was the same result. After reading your 2nd idea, I believe I’ve already...

Hi, Today I installed a Cooler master Master liquid 240L v2 rgb AIO into my new pc. My motherboard is a Gigabyte z690 aorus elite ax ddr5. When I log into the bios, the cpu is at 50º-70º and the rpm meter for the pump goes from 0, to 45 for 2 seconds, to 0, to 65 and back to 0, and so on...