Recent content by Dirtnapper01

Solved. After spending hours trobleshooting this issue, I finally got it resolved. Forwhatever reason the full Brother software pkg could not load the scanner driver. Last attempt was to just download the printer and scanner driver alone, leaving the CC4 software in installed, and it worked...

Scanner is connected to router. Yes, software is from Brother. Brother tools panel shows scanner driver not loading. Gigabyte Z790 D DDR4 Intel i7 14700K Samsung M.2 990 Pro Corsair Vengeance Pro DDR4 64GB NVIDIA GeForce GTX 1660 Super ViewSonic VP3256 Win 11 24H2 Build 26100.2161

Latest firmware.

Can not install brother software in safe mode, Win11 says Print Spooler can not be started in safe mode.

I have a MFC L2740DW unit. The scanner driver will not load. I have turned off Firewall and that did not help. I uninstalled Brother software and unit and reinstallled. I am using Win 11 24H2, build 26100.2161. Ideas? Thanks.

Thanks....I think I still have the box so I will check for the cable. I did have the box and found the cable.

I just got a Gigabyte Z790 D DDR4 mobo. I used the ATX 12v 2x4 , but I still have a section 12v 2x2 open, I do not have another power plug, is that if I was to OC. I am using a EVGA Super Nova 852 G2 power supply. Thanks

I just got off the phone with Viewsonic, they think the panel is defective. I was told it should stay on for 15 seconds and you can extend that in the main menu. All I get is a flash of the OSD. I will try your suggestion before I return tomorrow. I like the monitor I just would like to get...

I've just replaced my Viewsonic VP2770 monitor with a Viewsonic VP3256. For the life of me I cannot get the OSD to stay on, it's just a flash and then it's gone. I would like to adjust the time-out. Sadly, I called ViewSonic and no help. Thanks.

Thanks!

I have a Brother MFX L2740DW printer/scanner. I set it up for wifi, works. My question, can I just plug this into the router without setting it up again?

I tried to add two more WD hd's' using the Marvel SATA since the Intel is full. I can see the drives if I switch to Intel but they do not show when connected on the Marvel SATA. Marvel drivers installed. Any ideas? Thanks.

Temps looks ok..... CPU 23C/73.4F SYS 30C/86F PCH 37c/9806F

Seated on the cpu. I thought that bracket would be tighter. Thanks.