Recent content by Ertrius

Thank you for reporting the issue. I hope to read them again soon.

What is wrong with Rubix_1011 Overclocking, Cooling & Water Cooling - Sticky? When I try to open them, I get 404 Not Found Error.

I finally finished my new hard line water cooled build. I started it up for its first post, but got a Q-Code of d7. I connected an older keyboard and then the Q-Code changed to d6. Nothing is showing on the monitor. I checked all the power supply connections on PSU and mother board. They all...

Thanks, I will only have just the SATA/Molex and ATX cable connected to the power supply. Everything else will be unplugged.

Oh, yes OK. I have a Aquacomputer Octo controller. I can connect the SATA cable that has the molex connector on it to the Octo with that. Then I will unplug all the fans from it and just leave the water pump connected. Thanks.

I read an article and some posts on different forums that the way to fill a loop with the coolant is to disconnect everything from the power supply except for the water pump and the 24-pin ATX cable. I have a bridge connector to plug into the 24-pin ATX cable that will jump pins 15 and 16. So...

Got the info I needed from another forum, thank you very much. 😑

Does anyone know which header on the mother board I should plug the radiator fans into for control and ARGB? Will the hubs that came with my fans work?

Thank you. I think the post is visible now.

Hey everyone, I am building a new PC and this will be my second PC build, but the first time I have water cooled it with hardline tubing. I have a few questions on connecting the fans. Im sure you have had many ask this same question I am about to ask, but I could not find any posts that answers...

Thanks, Captain. I read an article that DDR4 may be the better choice. But, I may have misunderstood that they were probably talking about only mobo`s that can use both DDR4 and 5.

Hey all, I am buying the Asus Z690 Hero mobo and a Intel 12900K CPU. I need some help with choosing DDR4 Or DDR 5. Will DDR4 work with the Z690? If so, what is the sweet spot for each? 5200Mhz for DDR5? 3600Mhz DDR4? I heard DDR4 would be the better choice because of the lower latency over DDR5...

No, the power cable will not lower your refresh rate. The 60Hz. frequency from your wall outlet is totally different and unrelated, from your monitors refresh rate.

The instructions for mine is to insert the flash drive in the monitor. That`s all it says.

Yep, formatted to FAT32.