Recent content by Gentleman Jim

The PSU is a Thermaltake 850 PSU and was just bought a week ago. Video is Geforce RTX 3050 Ventus 2x from MSI also bought 1 week ago. M2 Drive is a WD black 1TB and ram is Kingston Fury DDR4 3200 16gb. Since my first post I have discovered that the BIOS are out of date by about 5 updates...

I have an Asus Prime z590m plus and I am having a continual error message of usb overcurrent. I have disconnected all of the usb cables / connections but continue to get the error. Any advice would be appreciated.

I have a Compaq Presario V5000, it will power on but I only hear the fan. I get no boot screen or any kind of screen and the dvd drive acts like it is trying to load a disk that is not there. I have also connected it to an external monitor and still get no screen. Thoughts and suggestions welcome.

I checked the system event log and it has two critical errors (both are when the computer stopped and rebooted) It showed the error was caused by the system stopped responding, crashed or lost power. I did not see a crash error message on the log. If the power might be an issue then I will look...

I ran the diagnostic and it came back with no memory errors found. I have not checked the system event log that will be the next step.

I have Windows 10 32 bit and everything is up to date. Recently I have had the computer lose video then reboot and this has happened two time while viewing Facebook. I am not sure if this is a RAM or video issue since thee is no error message displayed. Any thoughts.

I have external usb hard drives and want to connect these to my network for attached storage. I was hoping the print server would act as an adapter.

Would a print server work for this?

I am trying to find out if there is an adapter that I can use to connect an external hard drive with usb to and rj45 connection. Linksys had something for this but the reviews looked pretty bad. I don't want to use a program like free NAS since I don't have the spare parts for it. Any...

The Bitdefender Firewall was the issue. I have always run a firewall besides Windows and up until this point I have not had any issues.

I just turned off my third party firewall and ..... I have internet and can connect! I am using Bitdefender so why was it causing this type of problem?

I have connection on all of the other devices. It shows the wireless has internet access but it will not connect and I have tried several different sites.

I have a Toshiba Laptop model C55D-C5271 running Windows 10. I have not turned the unit on in about 2-3 weeks and I powered it up yesterday only to find that I could not connect to the internet. I have connections and it shows I have internet access but it will not connect. I have connection...

Once you turn the computer on press F2 and/or delete and this should get you into the bios. Also in an earlier thread you stated the processor was not supported, some support on board video (vga on the board) and some require a video card.

What graphics card did you upgrade to? Some cards have a network controller as part of the software that is downloaded when installing a new card and this controller can cause problems like the ones you listed. It usually shows up in the tray in the botton right corner of the screen. If you find...