Recent content by k1dfue

usb wifi is at the back plugged on the motherboard itself, asus prime a320m-k motherboard, bios version 6062 , im on windows 10

hi, I have a tplink TL-WA855RE repeater on the ground floor repeated from the main router with a 50mbps internet on the 2nd floor my phone and a desktop PC with a tplink usb wifi adapter TL-WN725N are connected to the repeater my phone has at least a 10mbps internet speed but the problem...

when you are broke you have to contend with a heaping pile of junk PSU :laughing: finally found the culprit it was a faulty ram, one of the 8 gb old a** stick

Connected with hdmi but already tried with other cable and the vga also still no video output

Cleared cmos, removed the drive, still no video signal I even tried removing the ram, still no video signal when turning on, all the fans have power even the motherboard lights are on but still no video signal

Booted pc without issue but right after logging in there was sudden red/blue /green pixels scattered across the screen, thought it was just the monitor, turn off then on the monitor but after turning on the monitor it has no signal anymore, restarted pc several times, used another monitor, still...

brand new bought online but came with no screws, the only screws that came with the board are 2 plastic packed screws for the board to use to attach on the pc case :unamused::laughing:

recently changed board from gigabyte A320 s2h v2 to asus prime A320M-K csm, the board had no screw for the m.2 ssd so i used the lone short screw from the gigabyte board as you can see from the attached pic the NVMe SSD is not parrallel to the board because of the short screw and the M.2 slot...

thanks for the replies, i guess reinstall would be best since it is just a new installation

i see, is it tricky to move the efi and recovery partition to the new disk?

i upgraded my old sandisk 240gb ssd to a 480gb kingston MVNE the way i installed windows on my mvne is using rufus on a bootable usb i did not clone the ssd as i needed a clean install as attached pics i tried to use diskpart to clean the old ssd but it wont let me saying it contains current...

just a side question, is it ok for the nvme m.2 to be screwed at an incline? the m.2 slot is a bit higher and the slot where the screw on the other end is a bit lower and the screw is short, so the nvme m.2 is installed at an incline not parallel to the motherboard

see attached screenshot edit: dont know why screenshot is not showing from imageshack cant sign up on imgur link posted below https://imageshack.com/i/pntEJLqPp

i recently replaced my storage and motherboard using Kingston NV2 500gb PCIe 4.0 NVMe M.2 Asus Prime A320m-K/CSM motherboards states "With x4 PCI Express 3.0/2.0 bandwidth, M.2 supports up to 32Gb/s data-transfer speeds" does that mean the ssd is using gen3 speed instead of gen 4? im confused...

My Ryzen 3 2200G clock has suddenly gone down and is steady at 500mhz, CPU power plan 100% max