Recent content by kobfreenet

It should work. U have an 850watt psu. And relatively fast processor.

Try downloading geforce experience and download driver from there. Maybe sounds stupid, but everytime I've uninstalled my 980 I can never install a driver without going through geforce experience??

Bit of an old thread, I know. Right click nvidia control panel. Under 3d settings select maximum performance mode. Should help:)

1

That's awesome mate but you see the country I live in , watercooling hasn't really been introduced on a large scale if you know what I mean . And ordering watercooling kits from abroad is really expensive for us but will keep your advice in mind , cheers :) [/quotemsg] Hi, Yeah I know its...

Watercool it. I have two gtx980ti in sli and they don't go over 47 on 98% load and overclocked to 1480mhz. Best way to do it.

I've been playing with DSR with v sync on, with 980ti sli and haven't seen any screen tearing. Try going into nvidia control panel and take it off use the 3d application setting and switch it on from there. What card are you using?

If I were you, I'd future proof your loop with a big enough resivour in case you up grade to a hotter card. I have two loops. One for CPU and one for my 980ti sli setup. They stay really cool while over clocked. Haven't got past 47degrees on 100% load, clocked to 1480MHz. My CPU on the other...

of course the graphics settings have to do with load. The Lower the graphics settings the lower the load. The higher the settings the higher the load, which will increase temperature. I've 2 780s in sli with a corsair 900d case and I get 68 degrees on witcher 2 ultra settings. It's all about...

If the block wasn't on correctly the cores would heat up. The core temps are fine, which means the block is doing its job ok. I used artic mx 4 or 5 can't remember which one of them. I used the pea method too. I have reseated it about 3 times just to make sure.

If I can't fix the heat problem for now. Is it so bad using 4 cores at 5GHz and keeping the other 4 disabled? Seeing as games will mainly use 2 to 4 core anyway.

I have cpuid HW monitor. I don't see what difference it would. Make. I've tested 3 temp monitors so far and they are all the same. Like I said core temp is fine it's just the socket that shoots up.

Hi I'm using cpuid and speed fan.

I have a water cooling loop on it. With an xspc 360 rad.

Hi all, Just looking for some advice as to why I can't keep my fx 9590 cool. At stock clock of 4.7GHz it is cool enough for gaming. But if irun occt the socket will heat up to 70c, but the cores will stay at a good temp of 40c.I turned the voltage down to 1.3375V and it's stable. I have a...