Recent content by Ljac95

I recently got a new ASUS TUF Geforce RTX 5080 OC. Initially when running under load it would boost up to 1725-1825mhz. I recently installed GPU Tweak 3 and since then it will only boost to 1670-1700mhz. Even after intalling the software and updating my drivers it still will not boost as high...

After trying various solutions I can get high performance to work but as soon as I deselect it and close the control panel it disappears again. Ultimate plan just will not work even though it says it has been successfully applied. I've even tried downloading the files but this seems to do...

Thanks for the link, Unfortunately none of them worked. Option 2 I couldn't try as the download is for windows 10 and option 4 the file it wanted me to adjust doesn't seem to exist on my system, not sure if this is the cause. I did notice if I manually add in a balanced plan via command prompt...

I have checked this section but it only offers screen and sleep settings, it almost seems like it missing features at this point.

I recently upgraded to Windows 11 but have just noticed that I only have the option for the balanced performance plan, It does not show any additional performance plans. I have tried adding them in manually using command prompt and power shell but they still will not display. Has anyone else...

Sounds like there is a good benefit from the extra radiators, unfortunately I’ve pretty much maxed out the radiator space in my fractal case.

Out of interest is it just the GPU on this loop and do you know how much power it draws under load?

Thanks for clarifying, I think part of the problem is I was comparing it to my water cooled 1080ti which I know realise has a much lower power draw

I have an Aorus RTX 3080 xtreme which I recently water cooled with Phanteks Glacier GPU block. I am running this with an i9-9900k (nothing is overclocked) using a 360mm and a 240mm radiator. In heavy gaming loads (AAA titles at 1440p) I can see GPU temperatures reach as high as 57 -58C and CPU...

I have tried running it without the front panel audio connected but there is still no output from the rear audio jacks

I didn’t know anything off and there is no physical evidence of any damage. The 3 pin connection is a jumper which switches the 3 pin DRGB header from 5V to 12V. I thought it was just a 3 pin rgb header and so I plugged the d rgb cable for the water block into it. When I switched on the PSU all...

Ill give this a go, I think I may also have a spare cable that I can try to just to rule that out too

Aorus Z390 Pro WiFi, I did try looking at ways to disable S/PDIF but can’t find anything. BIOS only has the option to disable the audio controller as a whole

One thing I have noticed is that my SPDIF out port has a red light on and is constantly showing as connected even with nothing in it, could this be the cause?

I'm not sure what kind of indicator this may be but if I go into the BIOS and disable audio controller I no longer get any static but this is obviously due to the ports being disabled but once re-enable audio controller in the BIOS the static restarts.