Recent content by Mlit

It's reassuring I can add more nodes to the same daisy chain then. But I would call in question your claim about the compatability of the JARGB V2 with the standard ARGB fans in this example. The fans work perfectly fine off it, no power issues, running some impressive light patterns. My...

My mistake, my system runs off the MSI B760 Tomahawk which has two JARGB_V2s and two older JRPGs. I am running fractal aspect rgb pwms largely due to my access of them. According to my previous quote from the google search they have six nodes in them if I'm getting it right. I also looked at a...

I'm googling my fan's led count. Search claims there are six in each fan: "It boasts enhanced blade efficiency, low turbulence and smooth rifle bearing to optimize system cooling, while six addressable RGB LEDs accent your powerhouse with fantastic lighting which can be synced with Asus Aura...

I've just transferred my system into a new case where I have four fans of the same manufacturer with rgb function and a further three intakes which are not rgb and which I'd like to eventually replace with identical fans to the others. I have these four fans' rgb connectors daisy chained to the...

PSU? That's interesting, I'd never considered that. My current one is a thermal take GF3 1650, very new but only keep it on default fan speed. However I'd only just turned the pc on when the artefacting happened. Havn't had it happen again, been powered on less than ten minutes at time of...

This morning I turned my pc on and did my normal routine and noticed a lot of artefacts appearing on the screen. On the text it's small pixels obscuring some of the letters and larger rectangles appear at the bottom of the screen and on the task bar. Print Screen will capture the letter pixels...

I'm in a very similar position myself. As you can't control rpms in the dedicated pump header, could users ofd the lumen instead plug it into a standard fan header?

I have gone and remounted the radiator to the front panel. I think it actually improves the cooling now. CPU in idle now hangs around 19-23 C though I didn't pay attention to exactly what it was before but it was certainly higher. It's also eliminated two surplus fans which would have cooled the...

I may remount the radiator at the front instead of in the ceiling like I have now then. But I do wonder in that case how I would manage to fit the tubing at the bottom when a graphics card is in the way.

I'm still a newbie to liquid cooling. Got my system stable after some issues, I do feel like my cooling isn't the best it should be like it should be a few degrees lower than it is. I've been struggling to find examples of how to apply good fan curves for my chassis, AIO fans and the radiator...

Will the bios have presets form what speeds it should ramp up to for specific workloads or do I need to enter the values?

Which software would you suggest for adjusting curves? I presume AIO Pump header was the correct header regardless for the pump?

I've only just gotten the system up the running. The TjMAX temps got me a little worried. Should the Lumen radiator be running at a 4000 ish rpm? It's fans are hooked to the CPU Fan header. I will probably look to get some better aftermarket case fans later. Anyhow BIOS version: 0415 ( Will...

I have just migrated my previous failed build from a meshlicious which I just could not get on with and with a faulty Lumen AIO into a larger Meshify 2 compact with the post recall fixed Lumen top mounted and set to exhaust air out of the case. Here I'm running OCCT and on the CPU Core Usage tab...

I did figure out the sound was my pump and lowering the rpm dealt with that, popped it down below 3000. But now I have a new problem that might be related. I started up Cyberpunk 2077 to test my specs and went through the first section until the bit where you pop the boot and my computer buzzed...