overclocking ram

so I tried setting my ram to 3600mhz. It didn’t post, so I removed the cmos battery for 10 minutes, put it back in, and still won’t post. Removed my gpu, still won’t post. All my rgb and fans are spinning, and I’m not sure what’s wrong. I’m thinking I have a dead motherboard. Any suggestions...

Hi, I have some problems with overclocking my RAM. i tried XMP profile 1 or 2 that didn't do nothing, i tried manually overclocking that didn't helpt. i dont know what the problem is, im also a newby with overclocking. My system: MSI MPG X570 GAMING EDGE WIFI AMD RYZEN 9 3900X G.SKILL...

Hi, I've recently bought a Corsair Vengeance RGB Pro 32 GB DDR4 3200 MHz RAM. I installed the rams then i turned on the PC, went in BiOS and set XMP profile. The profile was set to 3200mhz as it is supposed to, but when it started to boot, it failed. I realised that my MOBO (Gigabyte Z370 HD3)...

Hi, I have a first gen Ryzen 1400, and according to AMD's website, it supports RAM up to 2667. I have an entry level ASRock motherboard, and my RAM is 2x8gb rated for 3000. My motherboard gives me two XMP settings, one at 2667 1.35V and the other at 2933 1.35V. Is it safe if I pick 2933 at...

Hi guys My question is that my motherboard is normally run at Ddr3 1600 mhz but I can Increase the mhz buy overclocking right? I have GSKILL 8GB (2x4GB) Trident X DDR3 2400MHz CL10 1.65V Dual Kit Ram. But it's working at 1600Mhz. I tried to use XMP to increase it but I can only choice 1600Mhz...

I had 8gb (2x4) ram in my computer but I decided to order 2 more 4gb sticks each to install on the computer and so get 16gb, after a lot of headache I was able to start the computer with the 4 sticks installed but my problem is that I can't use the 2 new sticks at the 2800mhz stock speed, the...

I would like to overclock 8Gb 2666 HyperX DDR4 memory with XMP profile with Clevo (Sager) PB51RF-G . I am quite new to XMP so I would like to ask some newbie questions: Do I need special Ram that has 3000Mhz rate to use in XMP or I can use normal 2666Mhz Ram? Why my XMP profiles(Default...

I have been experimenting with the Ryzen DRAM Calculator (ver. 1.6.0.3) over the past week or so, and have been able to successfully tighten all timings on my Flare X 3200 CL14 (2x8) (F4-3200C14D-16GFX) memory kit. However, when I attempt to also use the calculator for boosting DRAM frequency...