I recently replaced both my CPU, Motherboard, CPU waterblock and Pump/Reservoir.
After I installed everything I made the mistake of not running/pre-filling the custom water loop (I forgot to use the 24 pin motherboard jumper to just run power to the pump to pre-fill the tubing with water)
Unfortunately, it took me a while to realize that as I tried to figure out what's wrong I turned the system on/off a couple times.
Then finally I noticed on the AMI screen warning me of "CPU Over Temparature Error" so I freaked out immediately and turned it off by hitting the PSU switch.
Once I finally realized my mistake I properly filled the loop and boot up the system normally while hoping and praying I didn't just permanently damaged my new CPU.
I've been running the system for couple hours now and task manager seems to be reflecting all cores/threads. I also took a HWMonitor screenshot below to ask if these numbers under load are normal? Thank you in advance.
After I installed everything I made the mistake of not running/pre-filling the custom water loop (I forgot to use the 24 pin motherboard jumper to just run power to the pump to pre-fill the tubing with water)
Unfortunately, it took me a while to realize that as I tried to figure out what's wrong I turned the system on/off a couple times.
Then finally I noticed on the AMI screen warning me of "CPU Over Temparature Error" so I freaked out immediately and turned it off by hitting the PSU switch.
Once I finally realized my mistake I properly filled the loop and boot up the system normally while hoping and praying I didn't just permanently damaged my new CPU.
I've been running the system for couple hours now and task manager seems to be reflecting all cores/threads. I also took a HWMonitor screenshot below to ask if these numbers under load are normal? Thank you in advance.