Question Abit IP-35 Long Repeating Beeps

[Gartri]

After starting the computer with four DDR2 RAM , all coolers start, but the speaker does not beep at all, there is no signal on the monitor. If I remove two ram, then after startup the computer starts with repeated long beeps(link). The video card and power supply are working fine, I checked it on another computer. Please help me, how to solve?😊

P.S. I reset the bios and took out the battery. All connectors on the motherboard are also intact, I cleaned the contacts on the RAM and video card. Phoenix BIOS

 

[Ralston18]

Is the RAM a matched set for dual channel use?

How did you install the RAM?

Check the motherboard's User Guide/Manual.

Some motherboards require that the first physically installed RAM be placed in a specific slot.

Verify that you have installed the RAM using supported RAM (specs) and in a supported RAM configuration (slots).

 

[Gartri]

Is the RAM a matched set for dual channel use?

How did you install the RAM?

Check the motherboard's User Guide/Manual.

Some motherboards require that the first physically installed RAM be placed in a specific slot.

Verify that you have installed the RAM using supported RAM (specs) and in a supported RAM configuration (slots).

This motherboard previously worked with these RAMs, so there should be no problems. Also the RAMs are the same, I didn’t swap them, they are inserted as before when the computer was working.

 

[Ralston18]

Beep codes:

I found the following old link:

https://www.overclockers.com/forums/threads/abit-bios-beep-codes.218664/

Double check the beep code/beep code pattern.

I also found the following manual - not able to verify if the manual is a match to your motherboard:

https://www.manualslib.com/manual/205153/Abit-Ip35-Pro.html?page=79#manual

However, the manual may provide some additional insight and troubleshooting assistance.

 

[Gartri]

Beep codes:

I found the following old link:

https://www.overclockers.com/forums/threads/abit-bios-beep-codes.218664/

Double check the beep code/beep code pattern.

I also found the following manual - not able to verify if the manual is a match to your motherboard:

https://www.manualslib.com/manual/205153/Abit-Ip35-Pro.html?page=79#manual

However, the manual may provide some additional insight and troubleshooting assistance.

Good evening, thank you for your help, I replaced the RAM and everything started working. Thank you very much again, I appreciate it.