Abit KT7-RAID help

[MP5A4]

I got a Duron 650 running at 892@1.85V in my A7v.
today i got a KT7-RAID Abit MB, and i plugged it in, with every other cards.
I setted the mutliplier and the voltage and stuff in the softmenu, and it doesn't work....
refuce to boot.. no posts no nothing, have to clear the CMOS and is working again.....
And now i can't even get it to work at all at any clockseed other then 650.
someone help! i can't even change the voltage or it'll not boot!

 

[Guest]

1. Are you using the latest <b>UL</b> BIOS?

2. Have you gone through the troubleshooting section and/or browsed through the KT7 FAQ at <A HREF="http://go.to/kt7faq" target="_new">http://go.to/kt7faq</A>?

3. Have you checked to make sure you didn't "re-lock" your processor while you were handling it?

Mike

 

[Guest]

BTW, I just noticed that you've posted the identical message in at least four different catagories. It's enough to just post it in one.

Mike

 

[MP5A4]

lets c...
1.No... what's UL?
2. No.. i'll check it out..
3. Yes.. i am sure...

And yea.. i though this is a dead forum where u know... 10 years goes by and one guy come over and c the post and may reply.. so i put in 4 of the forums... not at least 4.. is 4.....

 

[MP5A4]

OK, flashed my BIOS, recheck the L1s.....
nwo it posts all the way up to 1Gz (!!!) but can boot nothing higher then 750...... hmm....... buy buy alhpa heatsink, hello watercool......