Question Are wifi antennas conductive, if there not insulated well?

[reaper89971]

I bought a universal wifi antenna and am not so sure about it. It does not seem to be insulated in any way.

https://www.amazon.com/gp/product/B07QDTXGGJ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Could i just use 26 gauge silicone wire instead and just solder it on to the little wifi card?

Then i would know the wire is insulated with silicone, i would put something on the end of the wire of course.

https://www.amazon.com/gp/product/B084TPX75K/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Here is the wifi card i am using

 

[COLGeek]

Those antennae are fine as is. You don't need to modify them in any way. Try routing them out of the way and as linear as possible and you'll be fine.

Please be careful. You keep asking related questions of significant safety concern.

 

[Lutfij]

The black length of wire running from the ipex connector is insulated.

 

[bill001g]

You are going to have to explain what you mean "insulated". They have a plastic coating not sure silicon is somehow better. In addition the antenna do not use simple wire. That is a coax wire with a center conductor for the signal along with a shield that goes around it. Think the coax cable used by tv or a cable modem just much smaller

In addition the wire used for wifi antenna is very specially designed to have low loss at the high frequeccies used. It is also very hard to get good solder joint, they need to be perfect to not causes loss of signal.

In the end don't mess with them. If you need some other length have them custom made if you can not buy premade cables of the proper length.

 

[NoraFoster]

You are going to have to explain what you mean "insulated". They have a plastic coating not sure silicon is somehow better. In addition the antenna do not use simple wire. That is a coax wire with a center conductor for the signal along with a shield that goes around it. Think the coax cable used by tv or a cable modem just much smaller

In addition the wire used for wifi antenna is very specially designed to have low loss at the high frequeccies used. It is also very hard to get good solder joint, they need to be perfect to not causes loss of signal.

In the end don't mess with them. If you need some other length have them custom made if you can not buy premade cables of the proper length.


Using 26 gauge silicone wire could work, as it provides insulation and flexibility. However, ensure the wire has the correct impedance (typically 50 ohms for Wi-Fi) to maintain signal quality. When soldering, be careful not to damage the Wi-Fi card, and protect the wire’s exposed end to prevent short circuits. My brother had a last-minute homework deadline, and we were in a panic. I quickly searched online and found domypaper.com website. Can anyone help me in searching for a site online where I can read reviews for the given link? Thanks in advance.

Can I ask something regarding this or should I start my own thread?

 

[Ralston18]

Start your own thread.

OP has been banned and this thread is being closed to further posts.