Hey I'm a new to the pc world. I've a Asrock B450 Steel Legend ATX motherboard. So I enabled XPM on my Corsair Vengeance RGB Pro 8GB 3200MHz. I've a Ryzen 3 3200G. Few days after enabling XMP, I went into the bios and suddenly the ram speed got back to 2133MHz. Btw the ram was smoothly running at 3200MHz before going to the bios. After that I again enabled XMP and so far no problem has occurred even if I go to the bios again. Was that incident something that I should worry about? Since I'm new, I am wondering if that behavior was normal or not.
Kinda same thing once again too, I disabled the led settings in the S5 mode. But it took me several reboots after disabling and enabling the setting and then finally getting the desired result. But things are now working fine. So is it all normal if these settings can sometimes be finicky? Do note that due to some power supply issues, I had to shut down my pc in the process quite a few times but only after saving and exiting from the bios. Thanks in advance.
Kinda same thing once again too, I disabled the led settings in the S5 mode. But it took me several reboots after disabling and enabling the setting and then finally getting the desired result. But things are now working fine. So is it all normal if these settings can sometimes be finicky? Do note that due to some power supply issues, I had to shut down my pc in the process quite a few times but only after saving and exiting from the bios. Thanks in advance.
Last edited: