Recently upgraded from Windows 8.1 to Windows 10.
This was where the issue began.
Upon turning on my computer, the loading/spinning dots will stop in the Asrock BIOS screen.
After a few seconds, the computer suddenly powers off completely.
Never had this issue with Windows 8.1, never had this issue with Windows 7.
Computer specs;
CPU: i7 2700k
MOBO: Asrock Z77 Extreme 4
GPU 1: AMD R9 390X
GPU 2: AMD R9 270X
RAM: 24gb total, 28+24
SSD 1: 120gb - OS and driver only storage.
SSD 2: 500gb - importan storage.
HDD 1: General storage.
PSU: TX950W Corsair
Monitor: 4 monitors. 3 generic, 1 Freesync 144hz monitor.
Can boot to safe mode.
After removing GPUs, computer will boot smoothly to integrated motherboard graphics.
After removing all drivers using DDU, computer will boot smoothly with GPUs installed but will fail to restart after drivers are installed.
Advice and solutions to my setup is appreciated.
This was where the issue began.
Upon turning on my computer, the loading/spinning dots will stop in the Asrock BIOS screen.
After a few seconds, the computer suddenly powers off completely.
Never had this issue with Windows 8.1, never had this issue with Windows 7.
Computer specs;
CPU: i7 2700k
MOBO: Asrock Z77 Extreme 4
GPU 1: AMD R9 390X
GPU 2: AMD R9 270X
RAM: 24gb total, 28+24
SSD 1: 120gb - OS and driver only storage.
SSD 2: 500gb - importan storage.
HDD 1: General storage.
PSU: TX950W Corsair
Monitor: 4 monitors. 3 generic, 1 Freesync 144hz monitor.
Can boot to safe mode.
After removing GPUs, computer will boot smoothly to integrated motherboard graphics.
After removing all drivers using DDU, computer will boot smoothly with GPUs installed but will fail to restart after drivers are installed.
Advice and solutions to my setup is appreciated.